How to replenish gas? If the high-purity sulfur hexafluoride is not handled properly, the leakage will cause air pollution.

Before inflation, vacuum the cylinder to remove oil and water. Sulfur hexafluoride manufacturers are strictly prohibited from overfilling gas cylinders and carefully recheck the weight. For liquid SF6, when the filling pressure is 7.8MPa, the filling coefficient is less than 1.2Kg/L.

The sulfur hexafluoride manufacturer adopts small air make-up device for GIS equipment in operation. Two high pressure hoses are respectively connected from the inlet and outlet of the SF6 gas treatment vehicle. The other end of the hose at the inlet side is connected to the gas cylinder interface, and the other end of the hose at the outlet side is connected to the inflation port of the GIS gas chamber.

After connection, open the corner valve of the gas cylinder. The sulfur hexafluoride gas from the gas cylinder flows through the high-pressure hose to the inlet valve, through the pressure reducing valve, evaporator, heater, filter valve, check valve to the outlet valve, and then enters the GIS gas chamber through the high-pressure hose. Hotline: 139-4929-0069.

The content of the article comes from the official website of sulfur hexafluoride manufacturer: www.feiriergas.com/